Milton's Construction installs MRCOOL ductless mini-split systems and DC inverter heat pumps in West Islip homes — authorized distributor and installer, all Town of Islip permits included.
A large portion of West Islip's housing stock — the ranches, split-levels, and Capes built through the 1970s — was heated with baseboard electric or oil-fired hot water systems and cooled with window units. There is no ductwork, and adding conventional forced-air ductwork to these homes is expensive and disruptive. MRCOOL ductless mini-split systems are the practical answer: wall-mounted indoor heads, a compact outdoor condenser, and refrigerant line sets that run through a small penetration in the wall.
As an authorized MRCOOL distributor and installer, Milton's Construction specifies the right system for your home's load and installs it properly — licensed electrical work, correct refrigerant line sizing, and Town of Islip permits for the mechanical and electrical work. For homes being expanded with an addition or in-law suite, a dedicated mini-split zone for the new space is almost always the right choice over extending an existing system.
West Islip's proximity to the Great South Bay means cooling loads can be substantial in summer, and the salt air environment is hard on equipment. MRCOOL DC inverter systems are designed for efficiency in exactly these conditions — the inverter compressor modulates continuously rather than cycling on and off, which holds indoor temperature and humidity more steadily than a conventional system. That humidity control matters in a South Shore home where summer indoor RH can climb into uncomfortable territory even on moderate days.
For the split-level layout common in West Islip, a multi-zone system is often the cleanest solution — one outdoor unit serving a head in the upper-level primary bedroom, one in the lower-level living space, and one in a newly finished room or in-law suite. Each zone runs independently. The primary bedroom stays cool at night without overcooling the rest of the house, and the in-law suite has its own control.
Mini-split installation in a West Islip home typically takes one to two days for a single-zone system and two to three days for a multi-zone setup. The work involves mounting the indoor head, setting the outdoor condenser on a pad or wall bracket, running refrigerant line sets and electrical whip through the wall, and connecting to a dedicated circuit at the panel. Town of Islip requires a mechanical permit for the HVAC work and an electrical permit for the dedicated circuit — we file both.
For homeowners in flood-zone areas south of Montauk Highway, outdoor condenser placement is an important consideration. Condensers should be elevated above the Base Flood Elevation on a proper mounting system, not set on a ground-level pad that will flood. We factor that into the installation design and can provide a condenser wall-mount or elevated pad as part of the scope.
Yes. Modern MRCOOL heat pump systems deliver efficient heat output down to temperatures well below freezing — adequate for Long Island winters. They are not the same as the early heat pumps that struggled at low temperatures. For homes with existing baseboard or oil heat, a mini-split typically handles the majority of heating load and the existing system serves as backup on the coldest nights.
Yes. The Town of Islip requires a mechanical permit for the HVAC equipment and an electrical permit for the dedicated circuit that powers the outdoor unit. We file both permits and schedule the required inspections. Unpermitted HVAC work can create issues with homeowners insurance and at resale.
Yes. On flood-zone lots, the outdoor condenser should be mounted above the Base Flood Elevation rather than on a ground-level slab. We can mount the condenser on a wall bracket or an elevated platform as part of the installation scope. Proper placement protects the equipment from flood damage and keeps you in compliance with NFIP requirements that affect your flood insurance.
Get a free, no-obligation estimate for your project today.
