Licensed plumbing for remodels, new construction and repairs — fixtures, rough-ins and re-pipes.
Licensed plumbing is the backbone of any construction or remodeling project, and it demands the same level of precision and accountability as the structural work surrounding it. At Milton's Construction, plumbing is not an afterthought handed off to a stranger — it is a fully integrated part of our design-build process, planned from the first consultation alongside the framing, electrical, and finish work. Whether you are remodeling a kitchen in West Babylon, adding a bathroom to a colonial in Smithtown, or building a new home from the ground up in southern New Jersey, our licensed plumbers work as part of the same crew responsible for your entire project.
For homeowners across Long Island, the Tri-State area, and beyond, working with a general contractor who carries licensed plumbing in-house means you never have to chase down a separate sub to fix a drain that was roughed in wrong or coordinate a water heater installation that nobody properly sequenced with the drywall schedule. Our team handles supply lines, drain and waste lines, vent stacks, fixture connections, water heaters, and whole-house re-pipes as a single, coordinated scope — with one point of contact, one timeline, and one guarantee backing every step.
Milton's Construction has been building and renovating homes and commercial properties since approximately 1985. In that time, we have seen exactly what happens when plumbing gets siloed: burst schedules, callback disputes, code violations that surface at final inspection, and homeowners caught in the middle. Our integrated approach eliminates all of that. Every plumbing scope we take on is planned during preconstruction, permitted through the appropriate municipality, inspected on schedule, and backed by our 100 percent satisfaction guarantee.
The communities we serve across Nassau County, Suffolk County, the five boroughs, Westchester, New Jersey, and Pennsylvania each carry their own code requirements, water quality considerations, and housing stock characteristics. A 1960s ranch in Babylon with galvanized supply lines needs a very different conversation than a new-construction two-story in Bergen County. Our team knows the regional landscape, understands what local inspectors are looking for, and brings that knowledge to bear on every estimate we write.
Our plumbing scope covers the full range of residential and light commercial work that arises in new construction, additions, and remodeling. On the new construction side, that means laying out and installing all rough-in supply and drain-waste-vent (DWV) piping before walls are closed, coordinating the plumbing rough-in inspection with the building department, and returning after drywall and finish work to set fixtures, connect appliances, and complete all trim-out. For remodels and additions, we handle everything from adding a new bathroom or wet bar to a finished basement to relocating an entire kitchen plumbing stack when a layout change demands it.
Specific services include: rough-in plumbing for new construction and additions; whole-house re-pipes replacing aging galvanized or deteriorated supply lines with modern PEX or copper; water heater installation and replacement, including traditional tank units, tankless on-demand systems, and hybrid heat-pump water heaters; fixture and faucet installation (sinks, toilets, tubs, showers, dishwashers, refrigerator ice lines, washing machine connections); supply line and shut-off valve upgrades; drain, waste, and vent line installation and modification; sump pump and ejector pump installation; and coordination of plumbing relocations when a remodel changes the footprint of a kitchen, bathroom, or laundry room.
We also handle repair and diagnostic work for existing plumbing as part of a broader renovation scope — identifying and addressing leaks, correcting improper venting that causes slow drains or gurgling, and replacing corroded or undersized supply lines discovered during demo. In older Long Island housing stock, discovering mid-century galvanized piping during a kitchen gut is common; we can work the re-pipe into the remodel scope so it does not become a separate project and a second disruption to your home.
The single most common source of schedule delays and budget overruns in residential remodeling is the handoff between trades. When your general contractor coordinates plumbing through an outside subcontractor, every change order, every inspection delay, and every conflict between the plumbing layout and the framing plan becomes a three-way negotiation. Accountability blurs. A general contractor who carries licensed plumbing in-house eliminates that friction entirely — the person responsible for your project schedule is the same person responsible for the pipe in your wall.
At Milton's Construction, preconstruction design happens before a single fixture is ordered. When we generate your full plans and review them with you, the plumbing layout is part of that conversation. We talk about where drains can realistically land given the existing waste stack, whether the water pressure in your neighborhood supports the fixture count you want, and how a second-story addition will affect your hot water delivery times. These are questions that get answered on paper, not discovered mid-project.
Our licensed plumbers work alongside our framing and finish carpenters on the same crew, which means plumbing rough-ins are completed in the correct sequence relative to the structural work rather than squeezed in reactively. Inspections are scheduled proactively, not as an afterthought. And when a detail changes — because details always change in renovation work — the plumber is in the same conversation as the project manager, not reachable only by a sub-to-GC phone chain.
For homeowners in the Tri-State area who have lived through a remodel where the plumber and the tile contractor blamed each other for a waterproofing gap, or where a bathroom addition sat framed for three weeks waiting on a sub to schedule the rough-in, the difference of an integrated team is tangible. It is not a marketing phrase — it is the practical result of four decades of building the operational model around accountability.
Remodeling plumbing is more complex than new construction plumbing in one important respect: you are working within a structure that already exists, with constraints the original builder set decades ago. The drain may fall in the wrong location for your new island. The vent stack may not be sized for the fixture count you want to add. The supply lines serving your current bathroom may be undersized galvanized pipe that will need to be replaced before it ever sees the new fixtures you are installing.
Kitchen remodels routinely involve relocating the sink, adding a dishwasher connection, roughing in for a pot filler, and sometimes moving the entire wet wall to accommodate a new layout. Our team evaluates the existing plumbing stack, determines what can be tied into versus what needs to be rerouted, and integrates all of that into the project estimate and timeline before work begins. There are no surprises billed mid-project because we found the drain in an inconvenient location — we look first.
Bathroom remodels and additions are where plumbing coordination has the greatest impact on the finished product. The difference between a shower that drains properly and one that pools, between a toilet that vents correctly and one that gurgles every time someone flushes two floors away, comes down to rough-in precision and DWV design. We carry that technical responsibility in-house, which means when you select your tile and fixtures with our design team, the plumbing layout behind the walls is already engineered to support them.
Home additions — whether a ground-floor in-law suite, a second-story expansion, or a four-season room with a utility sink — each carry unique plumbing coordination requirements. Tying a new bathroom into an existing waste stack requires calculating fixture units, verifying the stack diameter, and confirming the municipal drain can handle the additional load. Our team handles all of that as part of the preconstruction phase, so your addition is permitted and built correctly the first time.
Beyond renovation plumbing, Milton's Construction handles whole-house plumbing upgrades that stand on their own or complement a larger remodel. Two of the most common we encounter on Long Island and throughout the Tri-State area are water heater replacement and whole-house re-pipe.
Water heater selection has expanded substantially over the past decade. Traditional 40- or 50-gallon tank units remain the most common and the most straightforward to replace, but tankless on-demand systems — which heat water only when the tap opens — have become a practical option for homeowners looking to recover mechanical room space or reduce standby energy loss. Hybrid heat-pump water heaters are a newer option that delivers significant energy savings in climates like the Northeast, drawing heat from surrounding air rather than generating it entirely with an electric element. We help you evaluate which type fits your household size, incoming gas or electrical capacity, and available footprint, and we install all three categories.
Whole-house re-pipes are a project many Long Island homeowners eventually face given the region's older housing stock. Galvanized steel supply lines installed in homes from the 1940s through the 1970s corrode from the inside out, progressively narrowing the interior diameter and eventually failing at fittings and joints. The symptoms are low pressure, rust-colored water, and recurring small leaks. A full re-pipe replaces all supply lines — typically with cross-linked polyethylene (PEX) tubing or copper, depending on the scope and the homeowner's preference — restoring full flow and eliminating the recurring leak calls. We run this work as a standalone project or integrate it into a kitchen or bathroom remodel when the walls are already opened.
For new construction — including our custom modular homes and site-built new homes across NY, NJ, and PA — all plumbing is installed to current code with appropriately sized supply, DWV, and vent systems designed for the floor plan. Nothing is undersized for future flexibility, and all rough-in locations are coordinated with the architectural plans generated during preconstruction.
Every plumbing project at Milton's Construction begins the same way every project begins: with a free in-home consultation and preconstruction design phase. For plumbing work, this means one of our team members walks the space, evaluates the existing plumbing infrastructure, reviews your goals for the project, and generates a written estimate that details exactly what is included. There are no line items that read 'plumbing allowance' and balloon later — the scope is specific.
Permits and inspections are not optional, and they are not an inconvenience. They are the mechanism that confirms the work is safe, code-compliant, and insurable. We evaluate permit requirements during preconstruction, pull all required permits as part of our scope, and schedule inspections at the appropriate milestones — typically rough-in inspection before walls close, and final inspection after trim-out. Our experience working with building departments across Long Island, New Jersey, and Pennsylvania means we know what local inspectors are looking for and how to prepare the work accordingly.
Timeline for plumbing work varies considerably based on scope. A single bathroom rough-in in an ongoing remodel takes one to two days for an experienced licensed plumber working in coordination with the framing crew. A whole-house re-pipe in an occupied home is a multi-day project and requires the water to be shut off during working hours; we sequence the work to minimize that disruption. A complete new construction plumbing installation, from foundation rough-in through final trim-out, spans multiple phases across the construction schedule and is coordinated into the master project timeline.
Investment in plumbing work is driven by several factors: linear footage of pipe, fixture count, whether the work is new installation versus modification of existing systems, accessibility of the work area, and local permit fees. We provide a detailed written estimate before any work begins, and we do not add charges mid-project for conditions we should have identified during preconstruction. Our commitment is transparent, honest pricing — the number on the estimate is the number you should expect to pay, barring changes in scope that you have approved in writing.
In virtually all municipalities across Nassau County, Suffolk County, and the broader Tri-State area, plumbing work that involves new installations, relocations, or whole-house re-pipes requires a permit and at least one inspection — typically a rough-in inspection before walls close and a final inspection after trim-out. Minor repairs such as replacing a faucet or swapping out a toilet generally do not require a permit, but any work that opens walls or changes the piping configuration does. Milton's Construction evaluates permit requirements during preconstruction and pulls all required permits as part of our scope.
Copper has been the standard residential supply pipe material for decades: it is durable, resistant to permeation, and has a long track record. PEX (cross-linked polyethylene) has become the dominant choice for new residential re-pipes because it is flexible, resistant to freeze-bursting, faster to install, and does not corrode. For most Long Island and Tri-State homeowners, PEX is the practical choice for a re-pipe. Copper remains a strong option if you prefer a fully rigid system or have specific water chemistry concerns worth discussing with our team. We install both and will walk you through the tradeoffs for your specific home.
Yes — relocating plumbing to fit a new layout is one of the most common things we handle during remodels. Moving a sink, relocating a toilet, or repositioning a shower drain all require re-routing the affected supply and drain-waste-vent lines, which is work that needs to be coordinated with the framing and subfloor. Because our plumbers work as part of the same integrated crew handling your entire remodel, these relocations are planned during preconstruction and executed in the correct sequence without the scheduling conflicts that arise when a separate sub is called in after framing is already closed.
The right water heater depends on your household size, fuel source (natural gas, propane, or electric), available space, and budget for both the unit and the operating cost over time. For most households, a standard natural gas tank unit remains the most cost-effective upfront option. Tankless on-demand water heaters make sense when space is at a premium or when a home has multiple bathrooms running simultaneously and a single tank cannot keep up. Hybrid heat-pump water heaters offer meaningful long-term energy savings for all-electric homes. We evaluate your specific situation during the consultation and provide options with honest tradeoffs rather than steering you toward any single product.
A whole-house re-pipe in a typical single-family home on Long Island takes two to four days depending on the size of the house, the accessibility of the existing piping, and whether walls need to be opened. The water supply must be shut off during active work hours, but we restore water service at the end of each workday so the home remains livable throughout the project. We schedule the work sequence to minimize disruption and coordinate any required patches to walls and ceilings as part of the overall project scope.
Yes. Milton's Construction has served both residential and commercial clients for four decades. Our licensed plumbing scope extends to light commercial work — retail buildouts, office renovations, and small commercial new construction across New York, New Jersey, and Pennsylvania. Commercial plumbing often involves larger fixture counts, grease traps, backflow preventers, and more complex permit requirements; our team is experienced with all of it and coordinates commercial plumbing as part of the same integrated design-build process we use on residential projects.
Discovering unexpected conditions — corroded galvanized lines, improper previous repairs, or undersized venting — is common when opening walls in older Long Island housing stock. Our policy is to document what we find, present you with the options and associated costs in writing, and get your approval before proceeding with any additional work. We do not proceed with undisclosed changes and then surprise you on the final invoice. Conditions discovered during demo that require changes to scope become a written change order, and we explain the reasoning clearly so you understand exactly what the work entails and why it matters.
One accountable team for every part of your project.
Open-concept kitchens with custom cabinetry, premium countertops, and layouts built around how you live.
Learn moreSpa-like bathrooms — freestanding tubs, custom tile, walk-in showers and warm, relaxing finishes.
Learn moreGround-up builds and full structural work, managed end to end — foundation, framing and every finish.
Learn moreGet a free, no-obligation estimate for your project today.