As an authorized MRCOOL installer, Milton's Construction brings ductless mini-split heat pump systems to Babylon Village homes — ideal for historic houses, flood-zone properties, and new additions without ductwork.
Most of the older homes in Babylon Village were built before central air conditioning existed. The Victorians and Colonials near Argyle Lake heat with baseboard or old forced-air systems, and cooling is often window units in a few rooms or nothing at all. Ductless mini-split systems are the right answer for homes like these — no ductwork required, each zone controlled independently, and heating and cooling in a single system that runs efficiently even in Long Island winters.
Milton's Construction is an authorized MRCOOL installer. MRCOOL DC inverter heat pump systems are particularly well-suited to South Shore conditions — quiet outdoor units, high efficiency at low outdoor temperatures, and the flexibility to serve one room or an entire house depending on how many indoor air handlers you install. We handle the full installation and tie-in to your existing electrical service. Call or text 631-741-0199 for a free written estimate.
Running new ductwork through a Victorian or historic Colonial is expensive and disruptive. Ceilings come down, walls open up, and the finished result in an older home rarely looks as clean as it does in new construction. A ductless system avoids all of that. The refrigerant line set runs through a small penetration in the exterior wall, the indoor air handler mounts high on the wall or in the ceiling, and the outdoor condenser sits on a pad or wall bracket outside. Installation is typically one to two days per zone.
For homes in Babylon Village's coastal flood zones, equipment placement matters. Outdoor condenser units on flood-prone lots should be elevated or mounted above base flood elevation — we account for that in the installation design. Channel-front and low-lying properties on the southern blocks of the village benefit from the flexibility mini-splits offer in equipment positioning.
If you're adding a dormer, a second-story addition, or an in-law suite to a Babylon Village home, heating and cooling that new space is a question that needs an answer before walls close up. Extending an existing duct system into an addition is often not practical — the existing equipment may not have the capacity, and running new ducts through finished framing is costly. A dedicated mini-split for the addition gives that space its own zone, its own thermostat, and doesn't put strain on the existing system.
We frequently install MRCOOL systems as part of addition projects we're already building. One team, one contract, one permit process. Call or text 631-741-0199 for a free written estimate covering both the addition and the HVAC.
Yes. Mechanical and electrical permits are required for HVAC installations through the Village of Babylon Building Department. We pull the permit and manage the inspection. MRCOOL systems installed by an authorized contractor like us carry full manufacturer warranty support.
MRCOOL DC inverter heat pumps are rated to deliver heat efficiently at outdoor temperatures well below freezing — down to minus 13 degrees Fahrenheit on some models. For typical Long Island winters, a properly sized mini-split system is a primary heating source, not a supplemental one. We size the system for your space during the estimate.
A single-zone system pairs one outdoor condenser with one indoor air handler — one room or one area. A multi-zone system uses a single larger outdoor condenser connected to two, three, four, or more indoor air handlers in different rooms, each with its own thermostat. For a whole-house installation in a Babylon Village Colonial or Victorian, a multi-zone system is typically the right approach.
Get a free, no-obligation estimate for your project today.
