Bathroom renovations for Wantagh homes — updated layouts, tile work, and code-compliant plumbing from a licensed contractor who pulls the Town of Hempstead permits.
Original bathrooms in Wantagh's Cape Cods and ranches were designed for efficiency, not comfort. A 5-by-7 square foot layout with a fiberglass tub-shower combo, a pedestal sink, and a single-bulb vanity light was the standard. After forty or fifty years, the real issues are often out of sight: galvanized supply lines that have narrowed with mineral buildup, original cast-iron drains that are corroding, and tile walls concealing moisture damage that started at the grout lines years ago.
We renovate bathrooms completely — from the studs out when needed, from the floor up when the structure is sound. Every job goes through Town of Hempstead permitting because plumbing and electrical work requires inspection to close out properly. For canal-area homes in Wantagh's southern neighborhoods, we apply the same moisture-management standards we use throughout the rest of the house: cement board backer, proper pan liners, and exhaust fans sized for the actual space.

The footprint of a postwar Wantagh bathroom usually cannot change without a structural addition, so good remodeling is about making 40 to 60 square feet feel and function better. A wall-hung vanity gains floor space visually. A walk-in shower with a linear drain and frameless glass makes a tight room feel larger than a tub alcove does. Recessed medicine cabinets and niche shelving in the shower add storage without adding bulk. These decisions compound — the right combination can make an original Cape bathroom feel genuinely generous.
When we open walls we deal honestly with what we find. Old galvanized pipe gets replaced with copper or PEX. Damaged blocking gets sister-framed. Cement board goes in before tile regardless of what was there before. The permit inspection at rough-in catches anything that needs correction before the walls close.


Many Wantagh Capes were built with a single full bathroom. Adding a second bath — whether in a converted bedroom corner, in a basement finish, or as part of a larger addition — is one of the highest-value upgrades for resale in Nassau County. It requires running new supply and drain lines from the existing stack, which is a permitted plumbing job. We plan the routing as part of the design so the new bath does not eat more space than necessary.
Cost for a new bathroom addition varies widely based on where the plumbing has to run and what finish level you choose. Typical ranges in Nassau County start in the mid-teens per thousand dollars and climb from there with tile grade and fixture selection. A free written estimate after a site visit gives you the actual number.






Yes, whenever plumbing or electrical work is part of the scope — which is nearly every full bathroom renovation. The Town of Hempstead requires inspection at rough-in before walls close. We manage the permit application and schedule inspections as part of our standard process.
Cracking tile in a shower or tub surround is often a sign of failed backer or a compromised pan liner, not just a surface issue. Water has likely been working behind the tile for some time. We open the wall to assess the damage, replace whatever is affected, and re-waterproof properly before tiling. Patching over cracked tile without addressing the cause is a short-term fix.
Yes. Many Cape Cod floor plans have enough space in an upstairs bedroom, a landing, or a lower level to accommodate a second full bath. The main challenge is routing new supply and drain lines to tie into the existing stack. We assess the plumbing path as part of the estimate so there are no surprises on labor once the job starts.
Get a free, no-obligation estimate for your project today.